How to Assemble a PAD Case

Updated

Follow the steps below to assemble a PAD case:

  1. Take the Y-Cable and plug the shorter cable into the Ingenico Device

    Y-Cable Ingenico Device

    y_cable2.png  

  2. Set the Ingenico Device into the Ingenico Holder and place the Y-Cable into the holder

    ingenico case.png  

  3. Place the Ingenico Holder, Y-Cable, and Ingenico Device on the top of the Back Cover, and use the four screws to close the cover, making sure the longest cable from the Y-Cable feeds into the Back Cover

    pad covers.png  

  4. Plug the Y-Cable into the PAD and set the PAD into the Back Cover. Make sure the PAD is lying flat and is secure
  5. Place the Front Cover on the Back Cover and press them together to lock them into place. If they don’t lock into place, check the PAD to ensure it is seated properly on the Back Cover

  6. Place the silicon Protective Cover on the Case, and press the sides into the case, ensuring a tight seal

    protective case.png  

  7. Slide the strap (end without the logo) into the bottom loop of the case. Feed it through the top loop and affix it to the other end. This will create a handle for the case

    Learn here how to disassemble a Tabit PAD case

Related articles